If your pilot light.
Wall heater pilot light went out.
5 improper air flow or a strong draft blows the pilot out.
Another cause of a weak pilot is a faulty thermocouple.
Louis area homes is when the pilot light goes out.
Pilot light issues are some of the most common problems experienced with gas water heaters.
Stays lit for a few seconds but goes out.
Without it the water heater won t be able to maintain internal temperatures allowing the water to cool off.
However if the light goes out frequently there could be other issues.
The heater won t operate properly if the pilot flickers is too weak or goes out and the cause could also be blockages in the pilot tube.
The pilot light in your hot water heater does more than simply ignite the gas.
Your thermocouple is responsible for sensing when your pilot light is lit.
You see the pilot light orifice controls the flow of gas to your pilot light.
If it senses that the pilot light has gone out the thermocouple shuts off the gas supply to the flame in order to prevent safety issues with your water heater.
One of the most common problems with aging furnaces in st.
This can happen on excessively windy days or nights.
Gas heater pilot light troubleshooting.
When the water heater pilot light goes out first try relighting it following the directions on the water heater label.
A leak in the output duct of the furnace could cause air to blow into the area.
Depending on the source of the problem this can either be a one time incident or something that happens over and over again.
Gas heaters whether they warm up air or water in a home rely on a pilot light to trigger the flame of the actual heater.
Some of the possible serious reasons for pilot lights to go out include loose or broken gas valves thermocouples or heat exchangers faulty venting low gas pressure or high winds.
Today we re going to talk about some of the most common reasons that a gas furnace pilot light would go out and what you should do if it happens to you.
If your pilot light re lights easily after going out overnight it s possible it was blown out by a draft.
The pilot light needs a strong flow of gas to make a strong steady blue flame that the thermocouple can sense.
When the pilot light goes out it does not leak carbon monoxide gas.
Has a weak yellow flame instead of blue then you most likely have a dirty or restricted pilot light orifice.
